ComAp Modules
Accessory modules to enhance the Inteli series of controllers. I-CR Module Used for CAN bus extension in cases where the maximum distance limit would be exceeded.
I-RB16 Module Interface module for electric separation of controller binary outputs. Available in 16 or 8 relay board and 24 VDC or 231 VAC contact modification.
I-CB Module I-CB is a communication device that bridges InteliDrive, InteliSys or Inteli NT controller and the electronic control unit of the engine.
I-LB / I-LB+ Bridge for sites with multiple controllers for local or remote monitoring and control.
DSE5110 BC
The DSE5110 BC is a 10 Amp battery charger designed for permanent
connection to automotive batteries, maintaining them in a fully charged condition without overcharging.
ComAp IGS-LOG
IGS-LOG is a software tool for continuous monitoring of single or multiple InteliGen and InteliSys applications.The software stores histories through direct, modem or Internet connection or from the saved file in off-line mode.
ComAp InteliSupervisor
InteliSupervisor is the Windows 98/NT/ME/2000/XP based monitoring and control software for fleet of gen-sets equipped with IG/IS/IM-NT and IG/IS controllers using Internet communication via IG-IB unit.
ComAp Gas Conversion Kit
The Gas Injection Control System has been developed to be used on supercharged gas and dual fuel engines. A higher fuel efficiency and steady output and speed are achieved by means of the precisely defined gas volume which is in due proportion to the engine output and speed.
M200-PLL & PLD
The M200-PLL & PLD are synchronising check relays, also known as paralleling relays. They are used to ensure at two AC supplies are synchronised. For a system to be synchronised, frequency, phase angle and voltage have to within pre-set limits.
ComAp InteliVision
The new InteliVision screen features many significant improvements such as the large high-resolution colour TFT display, which helps visibility and definition for onscreen information.